User Guide

Changing the oil filters

Remove the bolt 1 and swing the brake fluid container sideward. Place

a receptacle underneath the engine to collect the drained oil.

Remove the 4 bolts

2 and dismount the two oil filter covers.

Using circlip pliers, you may now pull the oil-filter inserts

3 out of the

housing.

Clean the oil filter cover, the sealing surfaces of the O-rings and the

engine casing.

Check the O-rings of the oil filter covers for damage and, if necessary,

replace them.

Put the motorcycle on its side and fill the oil filter housings about halfway

with engine oil. Insert the long oil filter at the front and the short oil filter

at the back of the housing.

Grease the O-rings

4 of the oil filter covers and mount the cover. Mount

the bolts and tighten them to 6 Nm/5 ft.lb.

Position the brake fluid container and tighten the bolt to 8 Nm/

6 ft.lb.

Return the motorcycle to an upright position.

Remove the oil dipstick

5 at the clutch cover and fill in 1.2 liters of fully

synthetic engine oil (Motorex Power Synt. 4T).

Start the engine and check all screwed connections and oil filter covers for

leaks.

Finally, check the engine oil level and, if necessary, correct it.

2-5C