Use and Care Manual

ManualsBrandsKrud Kutter ManualsCleaning1 gal. Concrete Clean and Etch

TECHNICAL DATA KRK-17

KRUD KUTTER

CONCRETE CLEAN & ETCH

Form: GDH-536

Rev.: 032317

.DESCRIPTION AND USES .

Krud Kutter

Concrete Clean & Etch formula is ideal for

cleaning, degreasing, and acid etching concrete floors,

walls, basements, driveways, swimming pools, patios, and

containment areas prior to coating, staining or sealing.

It creates a porous surface, and provides the even profile

and uniform appearance preferred for clear coating

applications. It can also be used to remove efflorescence

(alkali salts) and to neutralize new concrete and new

mortar joints on block, masonry and brick.

NO TOXIC RUN-OFF. WILL NOT HARM PLANTS,

GRASS, OR SURROUNDING VEGETATION!

PRODUCTS .

SKU Description

CE326 32 oz. Bottle

CE012 1-Gallon Bottle

PRODUCT APPLICATION .

DIRECTIONS

Mix ⅓ gallon (43 oz.) of concentrate with 1 gallon of water

in a plastic sprinkling can. One gallon of concentrate will

produce 4 gallons of premix; sufficient to cover 800 sq. ft.

Hot water will accelerate cleaning and etching. Sweep the

surface to remove loose debris, and scrape off excess

grease and oil. Cleaning a 10'x10' section at a time,

dampen the surface with a fine spray of water, and using

the sprinkling can, apply the premix evenly over

the surface. Scrub the premix into the surface with a stiff

bristled broom until the foaming stops.

NOTE: If no foaming occurs, surface has been previously

sealed and this will prevent penetration of premix. Remove

the sealer and reapply Krud Kutter Clean & Etch premix.

Triple rinse the surface with a water hose. Scrub while

rinsing to ensure removal of all loosened material. Allow

the surface to dry thoroughly before applying stain or

sealant. After the surface has dried, check any glossy or

oily areas by applying a few drops of water. If water does

not penetrate quickly, re-etch the affected areas.

WARNING: CONTAINS PHOSPHORIC ACID. SEVERE

EYE AND SKIN IRRITANT. In case of contact with eyes

or skin, flush with water for at least 15 minutes. If irritation

persists, seek medical attention. If swallowed, take large

amounts of water. Do not induce vomiting. Get medical

attention.

KEEP OUT OF REACH OF CHILDREN.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA KRK-17 KRUD KUTTER® CONCRETE CLEAN & ETCH .DESCRIPTION AND USES PRODUCT APPLICATION . ® DIRECTIONS Krud Kutter Concrete Clean & Etch formula is ideal for cleaning, degreasing, and acid etching concrete floors, walls, basements, driveways, swimming pools, patios, and containment areas prior to coating, staining or sealing. Mix ⅓ gallon (43 oz.) of concentrate with 1 gallon of water in a plastic sprinkling can.
PAGE 2
TECHNICAL DATA KRUD KUTTER® CONCRETE CLEAN & ETCH .PHYSICAL PROPERTIES . CONCRETE CLEAN & ETCH Composition Phosphoric Acid and Proprietary Ingredients Color Translucent Orange pH <1.5 VOC 0% 32 ounces – 200-300 square feet 1-Gallon – 800-1,200 square feet Practical Coverage Shelf Life NA Flash Point Caution! Non-flammable WARNING: CONTAINS PHOSPHORIC ACID. SEVERE EYE AND SKIN IRRITANT. In case of contact with eyes or skin, flush with water for at least 15 minutes.