Manual

21
small brush, pipe cleaner, or cotton swab to
remove remaining debris. Wipe the groove
clean. Lubricate the ejector and ejector groo-
ve with a light coat of Gun Pro, and reinstall
the ejector.
Place the spring in the hole. Insert the ejector
into the ejector groove, being certain that
the ejector is on the proper side. When the
ejector is on the proper side, the machined
recess on the front outside of the ejector
opens downward. (See illus. 20).
Push the ejector in until the front end of the
ejector is even with the hole. Place a small
dab of GG on the spring and place the ball
over the spring in the hole. Use a 3 mm
punch, the open end of a retracted ball-point
pen, or the eraser end of a pencil to push the
ball against the spring and into the hole.
Removing, Cleaning, and Reinstalling K-80 New Style Ejectors
(K-80 new style since 1990 / K-20)
left
left
right
right
20