User manual

Key Operator Mode 9-11
Key Operator Mode
Set initial output mode to be effective after power is turned on or after Auto Reset occurs.
❒ Setting options: Non-sort; Sort; Staple; Group
1 While pressing [OK], turn power ON. Enter the key operator password, then press [OK].
2 Press [F1 (▼)] and [F2 (▲)] to display “ 1: Initial Setting”, and press [OK]. The Initial setting
menu screen will be displayed.
3 Press [F1 (▼)] and [F2 (▲)] to display “ 5: Output mode”, and press [OK]. The Output mode
initial setting screen will be displayed. The default setting is Non-sort.
Initial setting menu screen Output mode initial setting screen
4 Press [F1 (▼)] and [F2 (▲)] to display a menu of “1: Non-sort”, “2: Sort”, “3: Staple-sort” or “4:
Group”, to select the initial output mode.
If Staple-sort is selected, Sort is automatically selected.
If an Output mode is incompatible, the menu will not appear.
5 Press [OK] to complete the setting.
6 If no further changes are required, proceed to step 9.
7 If other initial setting changes are required, press [F4 (PREV)] to return to the Initial setting
menu screen. Press [F1 (▼)] and [F2 (▲)] to select another desired menu item, from [1]~[5].
8 If no other initial settings are required, press [F4 (PREV)] to restore the Key operator
mode screen.
9 Turn power OFF.
10 Turn the copier power switch back ON to perform copying operations.
Preset/User Set Ratio(s) [2]
Preset and User set ratios are used to reduce and enlarge the original image to accommodate copy
paper size, and are available to the user when Lens Mode is selected from the Basic screen. The
displayed ratios may be changed by the Key Operator as shown below.