Installation Guide

19. Install the Centerguide
From the outside of the shower, slide panel to one side.
Tilt panel approximately 3″ (76 mm) into the shower.
Insert the centerguide rail into the open channel of the bottom frame as shown.
Allow the panel to swing back to its original position.
Center the centerguide on the shower base/bath ledge.
Lift the threshold and push completely down over the centerguide connector. You should hear the
connector snap into the threshold groove, and the threshold should sit flat on the shower base/bath
ledge.
Rail
Connector
Bottom
Frame
Ledge
1314827-2-B 22 Kohler Co.