Specification

Required Accessories continued
K-306-KS HiFlow Rite-Temp
®
valve with integral stops, NPT connections OR ❑ NA
K-304-KP Rite-Temp
®
valve with PVC connections ❑ NA
88526 HiFlow Rite-Temp
®
thin wall installation kit* ❑ CP ❑ Other
* Required when using the K-306-KS valve in a fiberglass or acrylic installation.
Optional Accessories
K-373 5-1/4″ (13.3 cm) diverter spout with 1/2″ NPT connections ❑ CP ❑ Other
K-373-S 5-1/4″ (13.3 cm) diverter spout with slip-fit connection ❑ CP ❑ Other
K-389 5-1/4″ (13.3 cm) diverter spout with 1/2″ NPT connections ❑ CP ❑ Other
K-389-S 5-1/4″ (13.3 cm) diverter spout with slip-fit connection ❑ CP ❑ Other
1030932 Deep roughing-in kit for Rite-Temp
®
valve (lever handles) ❑ CP ❑ Other
Installation Notes
WARNING: Risk of damage to the K-306-KS
valve assembly. When using the K-306-KS valve
in a fiberglass or acrylic installation, use the thin
wall installation kit (88526).
Install this product according to the installation guide.
Install the Rite-Temp
®
valve according to the valve installation
guide.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″ (45.7
cm) with single elbow between valve and wall-mount spout, if
used.
1/2" NPT
1/2" Hot
1/2" Cold
Top of Rim
4-7/16" (11.3 cm)
7" (17.8 cm) D.
Complete Bath and Shower Faucet with Rite-Temp
Valve and Slip-Fit Diverter Spout Shown.
For Slip-Fit Spout,
5/8" OD Tubing Must Extend
1-1/2" (3.8 cm) Min; to
2-7/8" (7.3 cm) Max
Beyond the Finished Wall.
3-1/2" (8.9 cm)
Thick Wall
2-3/4" (7 cm)
Thin Wall
5-5/8"
(14.3 cm)
5-1/2"
(14 cm)
72" (182.9 cm)-
78" (198.1 cm)
To Floor (Typical)
10"
(25.4 cm)
4"
(10.2 cm)
48" (121.9 cm)
To Floor
(Shower Only)
Product Diagram
DEVONSHIRE
®
RITE-TEMP
®
DEVONSHIRE
®
RITE-TEMP
®
PRESSURE-BALANCING BATH/SHOWER VALVE TRIM
Page2of2
1038207-4-
B