Specification

Required Accessories continued
K-2971-KS** HiFlow Rite-Temp valve with stops OR ❑ NA
K-11748-** Rite-Temp valve with push-button diverter ❑ NA
* Requires 1016453-C/F diverter button kit.
** For a complete listing of all the Rite-Temp valves, refer to the individual valve Specification Sheet or Roughing-In Sheet.
Optional Accessories
88526 Thin wall installation kit for K-2971-KS HiFlow Rite-Temp valve ❑ CP ❑ Other ____
1016453 Diverter button kit for K-305-K or K-305-KS Rite-Temp valve ❑ CP ❑ Other ____
1111613 Deep rough-in kit for Rite-Temp valve ❑ CP ❑ Other ____
Installation Notes
Install this product according to the installation guide.
NOTICE: For K-305 valve: The diverter button kit
(1016453-C/F) is required.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install a shut-off device on
either valve outlet.
Cap the shower outlet if the deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install straight pipe or tube drop of 7″ (178 mm) to 18″
(457 mm) with single elbow between the valve and the
wall-mount spout.
7-7/8" (200 mm)
3-1/16"
(78 mm)
7"
(178 mm)
7-9/16"
(192 mm)
4-1/2"
(114 mm)
2-3/4"
(70 mm)
4-7/16"
(113 mm)
6-5/16"
(160 mm)
10" (254 mm)
to Spout
(Bath Only)
72" (1829 mm)
78" (1981 mm)
to Floor (Typical)
48" (1219 mm)
to Floor (Shower Only)
4"
(102 mm)
For slip fit spout, 1/2"
nominal tube must extend
1-3/16" (30 mm) beyond
finished wall.
1/2" NPT
Top of the Rim
Ø 1-1/8" Max
Hole in the Wall.
Supply tube must
be centered in the hole.
Product Diagram
STANCETM
STANCETM BATH & SHOWER TRIM SET
Page2of2
1117233-4-
E