Dimensions Guide

General
Notes
Technical Information
Install this product according to the installation
guide.
All product dimensions are nominal.
Wall-mountVanity type:
Decorative cabinet hardware is not supplied.
Refer to the KOHLER bath accessories line for
recommended cabinet hardware to complement
your vanity.
To properly support the weight of the vanity and
sink, secure to stud framing or 2x6 bracing behind
the finished wall.
Select 500 lb (227 kg) load bearing 5/16" lag bolts
with a length to clear obstacles in the wall and
5/16" washers
Plan for electrical service if installing the optional
electrical strip. Any electrical accessory
components must be connected to a circuit
protected by a Ground-Fault Circuit-Interrupter
(GFCI) or Residual Current Device (RCD).
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
9-28-2018 15:55
Damask
®
Vanity
K-99563