Installation Guide

Prepare the Blower (Remote Site) (cont.)
•
Electrician pliers
•
Assorted screwdrivers
•
Adjustable wrench
•
Drill and bits to install the blower mounting fasteners
•
18 AWG non-metallic sheathed cable, two conductors with ground, with support clips, as required
•
One 4″ (102 mm) x 2″ (51 mm) electrical junction box with cover, gasket, and mounting screws
•
Three strain reliefs - one must fit the blower motor cover with standard National Pipe Thread (NPT)
threads. The other two must fit the holes in the new junction box.
•
Six wire connectors (wire nuts or equivalent)
•
1-1/2″ PVC or other rigid pipe with fittings, unions, PVC cement (or equivalent fastening method),
and support clips, as required
•
Four fasteners (such as flathead wood screws or concrete anchors) to secure the blower motor
•
Solid copper 8-gauge bonding wire, 36″ (914 mm)
1198327-2-B 4 Kohler Co.