Installation Guide

1. Prepare the Site
NOTE: Required mounting plate locations vary by model. The wall may be higher
than 21-1/2″ (54.6 cm), but the hole for the mounting bracket must be a certain height
from the floor for your specific model. Refer to the illustration above for mounting
bracket locations.
Construct a 2x4 surround around the overflowing bath. For other bathing fixtures,
reference the dimensions for your chosen installation.
For K-8359 only: depending on the design of the finished wall, the 2x4 may be cut
down to fit flush with the rough wall exterior and match the overflowing bath
outer rim height.
Locate the position on the surround framing where the spout will be mounted
and mark the side of the top and base 2x4.
From the base 2x4 mark, measure 3-1/4″ (8.3 cm) from the outside surface of the
surround framing. Mark this location on the floor.
Cut a 7/8″ (2.2 cm) hole for the stem mounting assembly.
Locate the height for the mounting plate hole according to the dimensions in the
illustration above for your specific model.
Drill a 1-1/4″ (3.2 cm) diameter by 2-1/4″ (5.7 cm) deep hole using the marked
location as the center point.
Spout Base Location
7/8" (2.2 cm) D. Hole
Emplacement de la base du bec
Orifice Ø 7/8" (2,2 cm)
Ubicación de la base del surtidor
Orificio de 7/8" (2,2 cm) D.
K-8359
K-8361
K-8362
3-1/4" (8.3 cm)
Mounting Plate Location
1-1/4" (3.2 cm) D. Hole
Emplacement de la plaque de fixation
Orifice drain Ø 1-1/4" (3,2 cm)
Ubicación de la placa de montaje
Orificio de 1-1/4" (3,2 cm) D.
= 20-1/2" (52.1 cm)
= 16-5/8" (42.2 cm)
= 18-5/8" (47.3 cm)
Mark here.
Marquer ici.
Marque aquí.
Kohler Co. 5 1089448-2-A