Installation Guide

7. Install the Overflow Hood
Attach the lift rod assembly to the overflow hood by placing the
lift rod eye and brass washer on the backside of the overflow
hood. Secure with the cotter pin provided.
Close the lift rod eye with a pliers.
NOTE: If the handle is not pre-assembled to the overflow hood,
secure the handle to the overflow hood with the provided screw at
this time.
Slide the lift rod assembly into the overflow ell and align the
overflow hood over the overflow ell.
Tighten the overflow hood to the overflow ell with the two
screws provided.
NOTE: If the overflow hood will be exposed to high volumes of
direct water spray, apply silicone sealant around the overflow hood.
This will create a watertight seal.
Overflow Hood
Overflow Hood
Screws
Cotter Pin
Lift Rod Eye
Lift Rod Assembly
Drain
Handle
Brass
Washer
Drain
Stopper
Kohler Co. 9 1054248-2-A