Installation Guide

Troubleshooting (cont.)
Faucet Troubleshooting Table
Symptoms Probable Causes Recommended Action
B. Handle is in
the closed
position.
B. Rotate the handle to the
open position. Refer to
the ″Faucet Operation″
section.
C. The hot
and/or cold
supply hose
is kinked.
C. Confirm the supply
hoses are not kinked. If
coiled, maintain an
inside diameter of 3″
(76 mm).
D. The outlet
hose is
kinked.
D. Confirm the solenoid
valve is located within
7″ (178 mm) to 8″ (203
mm) of the faucet
centerline.
E. Handle LED
is not lit.
E. Refer to the ″Handle
Switch Troubleshooting
Table.″
F. Power LED
on circuit
board is not
lit.
F. Refer to the ″Sensor
Troubleshooting Table.″
G. One or more
screens are
clogged.
G. Refer to the ″Cleaning
the Screens″ section.
2. Low water flow. A. The supply
stops are
partially
closed.
A. Confirm the supply
stops are fully open.
B. Handle is
partially
closed.
B. Rotate the handle to the
full open position.
C. The hot
and/or cold
supply hose
is kinked or
twisted.
C. Confirm the supply
hoses are not kinked or
twisted. If coiled,
maintain an inside
diameter of 3″ (76 mm).
D. The outlet
hose is
kinked.
D. Confirm the solenoid
valve is located within
7″ (178 mm) to 8″ (203
mm) of the faucet
centerline.
1276182-2-A 16 Kohler Co.