Use and Care Manual

Shower Doors

For best results, keep the following in mind when caring for your KOHLER®

product:

 Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

 Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray

that lands on nearby surfaces.

 Do not allow cleaner to soak.

 Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean

surfaces.

 For warranty information call 1-800-4KOHLER (1-800-456-4537).

* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the

water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being

cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.

_____________________________________________________________________________________________

CleanCoat Technology

The use of abrasive cleaners is not recommended for glass doors treated with CleanCoat®. Simply wipe down

CleanCoat doors regularly with a soft cloth and water or a squeegee to keep the glass looking clean.

NOTE: The “Products to Consider” may be used on CleanCoat glass, but are not necessary.

 Use a shower squeegee to clean glass doors after showering to help prevent water spots.

 To avoid soap deposits or lime buildup in hard water areas, wipe the door dry after each use.

PAGE 1
Shower Doors For best results, keep the following in mind when caring for your KOHLER® product:      Always test your cleaning solution on an inconspicuous area before applying to the entire surface. Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray that lands on nearby surfaces. Do not allow cleaner to soak. Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.
PAGE 2
 Occasionally wipe the doors with a mild detergent diluted in water to keep the door looking new.  Never use bristle brushes, abrasive sponges or cleaners, or sharp instruments on the glass panels or anodized aluminum. They can scratch some glass and metal surfaces.  For metal surfaces, never use cleaners containing abrasives, ammonia, bleach, acids, waxes, alcohol or solvents as they may damage the finish. Use of harsh cleaning agents may void warranty obligations.