Installation Guide

7. Install the Strike Jamb and Strike Jamb Cap
Install Strike Jamb
Locate the strike jamb on the opposite wall, behind the threshold. Use the installed door to
determine the position of the strike jamb when the door is closed. Mark the location with a pencil.
Using a 5/16″ drill bit, drill holes using the pre-punched holes located in the jamb as a guide. Insert
anchors into wall. Secure the strike jamb using three of the #8-18 x 1-1/2″ screws provided.
Install Strike Jamb Cap
Snap the strike jamb cap into place.
Strike Jamb
Strike Jamb
Threshold
Screw
Anchor
Use door as a guide to
position strike jamb.
Install strike jamb using
three #8-18 x 1-1/2" screws
and wall anchors provided.
Locate strike jamb
behind threshold.
Snap strike jamb
cap into strike jamb.
Strike Jamb Cap
(Installed)
1011451-2-F 10 Kohler Co.