Installation Guide

11. Install the Handles
Identify the inside handle and brackets – with non-threaded holes. Assemble the inside brackets and
handle with 2 #8 x 4-1/2″ flathead screws as shown.
Place a bushing onto each screw as shown.
Position the inside handle assembly onto the door panel by carefully inserting the two screws
through the holes in the glass.
Place a second bushing onto each screw and into the glass holes.
Assemble the outside brackets and handle as shown and attach to the inside handle by
hand-tightening the screws.
NOTICE: Do not overtighten. Overtightening can cause damage to the door panel.
Using the 3/32″ hex wrench provided, tighten the screws to secure the handle in place.
Bushing
Hex Wrench
Inside Bracket
Inside Handle
Screw
Outside Handle
Outside Bracket
Kohler Co. 15 1144163-2-B