Installation Guide

6. Install the Side Panel
Install the Side Panel
Measure the width of the side panel.
From the wall jamb where the side panel will be installed, mark the measured width on the
threshold.
Apply a bead of silicone sealant along the top of the threshold from the wall jamb to the marked
location.
Orient the side panel with the label toward the wall jamb and the bottom lip toward the inside of
the shower.
Place the side panel onto the threshold and slide it flush against the wall jamb.
Verify the side panel sits flush on the threshold.
Using a 7/64″ drill bit, drill a hole into the threshold through each of the 2 predrilled holes in the
lip of the side panel.
Secure the side panel to the threshold using two #6-32 x 3/8″ panhead screws.
Install the Side Panel Filler
Slide the bulb seal into the T-slot groove on the filler.
Use scissors or a utility knife to cut any excess bulb seal away so the seal is flush with the top of
the filler.
From inside the shower, insert the filler between the wall jamb side panel with the bulb seal and flat
surface of the filler toward the side panel.
Using the pre-drilled holes in the wall jamb, drill 1/8″ holes into the filler.
Filler
Screw
Lip
Hinge Seal
#6-32 x 3/8"
Panhead Screw
Bulb Seal
Filler
T-slot
Kohler Co. 9 1144162-2-B