Installation Guide

6. Assemble the Door
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass edge directly on the floor.
Align the slotted holes on the hinge with the channel in the door panel. Make sure the top edge of
the hinge assembly is flush with the top of the channel.
Secure the hinge to the door panel using four #8-18 x 3/8″ panhead screws (provided).
Install the hinge jamb cover on the top of the hinge jamb where it aligns with the edge of door.
Starting on the hinge side of the glass, press the bottom seal onto the bottom of the door panel.
NOTE: Leave a small gap at the handle side of the door for clearance from the strike jamb. The door will
not close properly without this gap.
Inside of
Shower
Threshold Seal
Top View
Bottom View
Door Panel Extrusion
Hinge Jamb Cover
Threshold Seal
Assemble, making sure
top edges are flush.
Channel
Hinge Jam Cover
Hinge Assembly
#8-18 x 3/8"
Screw
Hinge
Jam Cover
Door Panel
Channel
1036565-2-D 10 Kohler Co.