Installation Guide

Replacing the Charging Batteries
NOTE: The red light on the docking station will blink when the batteries are low. The ″Stop″ icon on the
remote control will blink when it has a low charge and should be returned to the docking station.
If the remote control is secured to the docking station, remove it and set aside.
Remove the docking station from the wall by carefully lifting up and out.
Open the back compartment on the docking station by pushing both tabs outward at the same time.
Install four AA batteries, oriented as shown in the battery compartment.
Reinstall the cover.
Reinstall the docking station on the wall.
Troubleshooting Information
NOTE: For service parts information, visit the product page at kohler.com/serviceparts.
Small Children
The automatic flush and cleansing features are activated by a sensor located under the seat. Small
children may not be tall enough to be detected by the sensor.
General
Symptoms Probable Causes Recommended Action
1. The toilet has no power. A. The power is not turned on. A. Press the ″power″ icon on the side
control panel.
B. The power is not connected. B. Check the power connection inside
the junction box.
2. The toilet has power but
does not flush.
A. No water being supplied to the
toilet.
A. Fully open the water supply stop.
3. No water sprays from the
wand or it has a weak
stream when activated.
A. The water supply stop is closed
or only partially open.
A. Fully open the water supply stop.
Back of Docking Station
1325704-5-A 12 Kohler Co.