Installation Guide

4. Install the Mounting Hardware
For K-5026 / K-5149 Only:
Using the appropriate sized drill bit for your lag bolts, drill pilot holes at the two
outer marked locations.
Using a 10 mm drill bit, drill pilot holes at the two inner marked locations.
Install the anchors and hanger bolts in the two inner holes.
For All Installations:
Using a 10 mm drill bit, drill pilot holes for the hanger bolts.
Install the anchors and hanger bolts.
Installer la boulonnerie de fixation
Pour les modèles K-5026/K-5149 uniquement:
Utiliser le type de mèche de la taille correcte pour les tire-fonds et percer des
trous-pilotes aux deux emplacements marqués sur l’extérieur.
Utiliser une mèche de 10 mm pour percer des trous pilotes aux deux
emplacements marqués à l’intérieur.
Install the anchors and bolts.
Installer les ancrages et les boulons.
Instale los anclajes y los pernos.
Verify the bolts are level.
Vérifier que les boulons sont à niveau.
Verifique que los pernos estén a nivel.
11"
(279 mm)
12
3
Drill pilot holes.
Percer des trous-pilotes.
Taladre los orificios guía.
Hanger Bolt
Boulon d'ancrage
Perno de sujeción
Anchor
Ancrage
Anclaje
Hanger Bolts
Boulons d'ancrage
Pernos de sujeción
1114336-2-B 10 Kohler Co.