Installation Guide

3. Install the Valve - Bath/Shower Application
NOTE: For installations that use a bath diverter spout and a
showerhead, install a twin ell (K-9663) between the valve and the
spout.
Install the valve on the support framing so the ″UP″ mark on the
valve is facing downward.
If the hot water supply is connected to the cold inlet, the cap
assembly must be rotated 180° to ensure proper orientation; see
the enlarged view showing the cap rotated 180°.
Install elbows and adapters (if needed) to 3/4″ copper tubing of
the proper length. Apply thread sealant, and connect the pipes to
the bath and shower outlets of the valve.
Cold Inlet
To
Showerhead
Hot
Inlet
Hot
Supply
Twin
Ell
Cold
Supply
10"
(254 mm)
To Spout
This feature faces downward
for bath/shower installation.
1205550-2-C 6 Kohler Co.