Installation Sheet

2. Prepare the Wall
58"
(1473 mm)
To Floor
Ø
1-1/4"
(32 mm)
From
V
alve
CAUTION: Risk of product damage. The ON/OFF switch must be installed
on a non-w
et surface outside of the shower.
CAUTION: Risk of property damage. Do not drill into cables or pipes behind
the w
all.
NOTE: If possible, install the product on a at and even wall surface, avoiding any
grout lines.
NOTE: The recommended height above the oor is 58" (1473 mm).
Mark the center of the ON/OFF switch installation location.
Drill a 1-1/4" (32 mm) hole at the center mark.
Feed the cable from the digital valve through the hole in the wall.
Using the provided cleaning wipe, clean the surface around the mounting hole
where the switch will contact the w
all. Allow 1 minute to dry.
Kohler Co. 5
1455842-2-A