Installation Guide

2. Install the Lavatory/Sink
Undercounter Installation
Cut out the opening by carefully following the pencil line traced
from the template.
NOTE: The screws and anchors provided should be used on
countertops with a minimum 1″ (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and fasteners (not provided).
For Wood Countertops
Mark and pre-drill the wood screw holes at the locations shown
on the template.
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect
the surface. Mark and drill 3/8″ holes 5/8″ (1.6 cm) deep at the
locations shown on the template.
Use a setting tool and hammer to secure the anchors.
For All Undercounter Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation
instructions.
Foam
Padding
Wood
Screw
Apply
sealant.
Anchor
Screw
Undercounter Installation
Marble
Setting Tool
Anchor
Clamp
Mortar or
Adhesive
Water Resistant Underlayment or
Backing Material 3/4" (1.9 cm)
Minimum
Route or shim
as required to
level tile.
Tile-In Installation
Lavatory
Sealant
Tile
Kohler Co. 5 1018893-2-D