Installation Guide

Install the Lavatory
Drill 1/4” mounting holes at the marked locations on the finished wall and the
floor.
NOTE: You may also use other fastening devices of sufficient size and strength.
Install the hanger bolts to the backing material so they extend 1” (2.5 cm) beyond
the finished wall.
Install the faucet and drain to the lavatory according to the manufacturer’s
instructions.
Move the pedestal over the drilled hole in the floor, and secure the pedestal to the
floor by carefully tightening the lag screw and washer.
Carefully set the lavatory on the pedestal so the hanger bolts extend through the
lavatory anchoring holes.
Verify the lavatory is positioned as desired.
Install the cap nuts and washers to the hanger bolts; carefully tighten until secure.
Do not overtighten.
Connect and tighten the trap to the drain, and complete the water supply
connections to the faucet according to the instructions packed with the faucet.
Run water into the lavatory and check all connections for leaks.
Installer le lavabo
Percer des orifices de fixation de 1/4″ aux emplacements marqués sur le mur fini
et le sol.
Washer
Rondelle
Arandela
Cap Nut
Écrou borgne
Tapón roscado
Hanger Bolt
Boulon d'ancrage
Perno de sujeción
1" (2.5 cm)
Washer
Rondelle
Arandela
Pedestal Base
Base de colonne
Base de pedestal
Lag Screw
Vis à tête carrée
Tornillo para madera
1/2" (1.3 cm) D.
Anchor Hole
Orifice d'ancrage
de Ø 1/2" (1,3 cm)
Orificio de anclaje
de 1/2" (1,3 cm) D.
Kohler Co. 7 1068258-2-A