Installation Guide

6. Install the Showerhead
CAUTION: Risk of product damage. To avoid plugging the
showerhead spray outlets, use thread sealant tape on the shower
arm threads. Do not use thread sealant compound (pipe dope).
Remove the temporary nipple.
Loosen the setscrew and apply a bead of plumbers putty or other
sealant around the wall flange according to putty manufacturer’s
instructions.
Slip the wall flange over the shower arm.
Place thread sealant on the shower arm threads and thread the
shower arm into the elbow.
Tighten with a clean strap wrench. Do not overtighten.
Flush out the system with the showerhead removed. Apply
thread sealant to the threads, and thread the showerhead onto the
shower arm.
Apply thread sealant to the threads, and thread the showerhead
onto the shower arm.
Press the wall flange tight against the wall and secure with the
setscrew.
7. Complete the Installation
Ensure that all connections are tight.
Open the drain.
Elbow
Showerhead
Shower Arm
Setscrew
Apply plumbers
putty
Wall Flange
1025256-2-B 8 Kohler Co.