Use and Care Manual

Chrome & Vibrant PVD Colors/Finishes

For best results, keep the following in mind when caring for your KOHLER®

product:

 Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

 Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray

that lands on nearby surfaces.

 Do not allow cleaner to soak.

 Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean

surfaces.

 For warranty information call 1-800-4KOHLER (1-800-456-4537).

* Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the

water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being

cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas.

_____________________________________________________________________________________________

 Do not use cleaners containing ammonia, bleach or acid.

 Rinse thoroughly and use a soft cloth to wipe the product dry after each use.

 The Oil-Rubbed Bronze finish should be cleaned only with Windex Original.

PAGE 1
Chrome & Vibrant PVD Colors/Finishes For best results, keep the following in mind when caring for your KOHLER® product:      Always test your cleaning solution on an inconspicuous area before applying to the entire surface. Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and dry any overspray that lands on nearby surfaces. Do not allow cleaner to soak. Use a soft, dampened sponge or cloth.
PAGE 2
Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact measurements of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas mentioned. Care Tip The ideal cleaning technique is to always blot dry any water from metal surfaces. Allowing water to evaporate on metal will form water deposits.