Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 50″ (1207 mm) x 24″ (610 mm)
Basin area, top 65″ (1651 mm) x 27″ (686 mm)
Weight 116 lbs (52.6 kg)
To overflow:
Water depth 14″ (356 mm)
Capacity 72 gal (272.5 L)
* Approximate measurements for comparison only.
VHzA
1-speed pump 120 60 7
Heated surface 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/Control/Heated
surface
120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under the bath whirlpool must provide for a
minimum of 41 lbs/square foot (200 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the pump.
20"
(508 mm)
36" (914 mm)
1"
(25 mm)
3"
(76 mm)
Integral Flange Detail
Recommended Faucet Area
No change in measurements if connected with
drain illustrated. (K-7166-AF)
1-1/4"
(32 mm)
3-1/2"
(89 mm)
2-7/8"
(73 mm)
1-1/4"
(32 mm)
1/2"
(13 mm) R.
10-1/4" (260 mm)
18"
(457 mm)
72" (1829 mm)
18"
(457 mm)
72" (1829 mm)
1-1/2" Bath Drain
21-1/4"
(540 mm)
Lumbar
Angle 42˚
Product Diagram
MARIPOSA
®
MARIPOSA
®
6’ BATH WHIRLPOOL WITH INTEGRAL APRON AND BASKTM
Page2of2
1201672-4-
B