Specification

Technical Information
Fixture:* basin area top area weight
Bathing
well
50″ (127 cm) x
24″ (61 cm)
65″ (165.1 cm)
x27″(68.6 cm)
102 lbs
(47.2 kg)
water depth capacity
To
overflow
14″ (35.6 cm) 72 gal.
(272.5 L)
* Approximate measurements for comparison only.
Blower
motor:
Heater Voltage Frequency Amperage
1 Hp 300 W 120 V 60 Hz 5 A
Included component:
Drop-in cut-out 70″ (177.8 cm) x 34″ (86.4 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under the bath must provide for a minimum of
80 lbs/square foot (390 kg/square meter).
A blower motor access panel is required.
If used, the optional apron must be installed before the
finished floor and wall materials are installed.
If installing a rim-mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
1-1/2"
(3.8 cm)
36" (91.4 cm)
72" (182.9 cm)
1" (2.5 cm)
3" (7.6 cm)
1-1/2" O.D.
2-7/8"
(7.3 cm)
Blower Access
20" (50.8 cm)
K-1257-GRF
& K-1257-G
18-1/2" (47 cm)
K-1257-G
18"
(45.7 cm)
10-1/4"
(26 cm)
1-13/16"
(4.6 cm)
21-1/4"
(54 cm)
K-1257-GRF
1-1/4"
(3.2 cm)
20" (50.8 cm) W x
15" (38.1 cm) H
3-1/2"
(8.9 cm)
No change in measurements with drain
shown. (K-7166-AF or K-7166M-AF)
Integral Flange Detail Drop-In Rim Detail
1-1/4"
(3.2 cm)
1/2" R.
(1.3 cm)
Product Diagram
MARIPOSATM 6’ BUBBLEMASSAGETM
MARIPOSATM 6’ BUBBLEMASSAGETM DROP-IN BATH WITH AIRJETS
Page2of2
1040121-4-
A