Specification

Technical Information
Fixture*: Basin area bottom Basin area top
Bathing well 45″ (114.3 cm) x
25-1/2″ (64.8 cm)
63″ (160 cm) x
31-1/2″ (80 cm)
Water depth to overflow 23-1/2″ (59.7 cm)
Capacity 142 gal (537.5 L)
Weight 275 lbs (124.7 kg)
* Approximate measurements for comparison only.
Drop-in cut-out 73-1/2″ (186.7 cm) x 39-1/2″ (100.3
cm)
Pump Heater Voltage Frequency Amperage
1.5 hp 4 kW 240 V 50/60 Hz 17 A
Required Electrical Service (2)
Two dedicated circuits required, each protected with
Class A Ground-Fault Circuit-Interrupter (GFCI) or
Earth-Leakage Circuit-Breaker (ELCB):
Pump/control 208-240 V, 20 A, 50/60 Hz
Heater 208-240 V, 20 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Two separate 240 V electrical services are required; one for
the pump/control, and another for the heater.
Floor support under the overflowing bath must provide for a
minimum of 2000 lbs (907.2 kg).
Consult local and national codes for minimum air gap
requirements when installing a spout on the bath deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Unit must be filled through the bathing well.
41"
(101.4 cm)
20-1/2"
(52.1 cm)
7-1/4"
(18.4 cm)
5-1/2" (14 cm)
63" (160 cm)
75" (190.5 cm)
16-13/16"
(42.7 cm)
3" (7.6 cm)
2-7/8" (7.3 cm)
1" (2.5 cm)
1" (2.5 cm)
2" (5.1 cm)
31-1/2" (80 cm)
Pump/Control Access
25"
(63.5 cm)
1-1/2" NPS
1-1/2" OD
No change in measurements with drain
shown. (K-7193 or K-7193M)
15" (38.1 cm) H x
40" (101.6 cm) W Min
Product Diagram
so¯kTM
so¯kTM OVERFLOWING BATH
Page2of2
1019732-4-
E