Specification

Technical Information
Fixture*:
Bathing well:
Basin area, bottom 51-3/8″ (1305 mm) x 21″ (533 mm)
Basin area, top 64-1/2″ (1638 mm) x 30-1/2″
(775 mm)
Weight 121 lbs (54.9 kg)
To overflow:
Water depth 15″ (381 mm)
Capacity 72 gal (273 L)
* Approximate measurements for comparison only.
WV HzA
Blower motor 300 120 60 10
Heated surface 65 120 60 .5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI).
Blower motor/Heated surface 120 V, 15 A, 60 Hz
Blower motor and heated surface are supplied with
separate 24″ (610 mm) grounding-type plug-in cords.
Installation Notes
Install this product according to the installation guide.
NOTICE: Relocation of the blower motor and check valve is
optional. Mount the blower motor and check valve together;
do not move one without the other. An additional access
panel is required for relocation. Provide an access panel at
the blower motor/control location.
Floor support under this product must provide for a minimum
of 42 lbs/square foot (201 kg/square meter) loading.
Will comply with ADA when installed per Section 607
Bathtubs of the ADA 2010 Standards for Accessible Design.
Locate a GFCI-protected 120 V, 15 A, grounded duplex
electrical outlet within 24″ (610 mm) of the blower motor.
36" (914 mm)
72" (1829 mm)
1-1/2"
Bath Drain
1/2" (13 mm) R.
3/4" (19 mm)
11-1/4"
(286 mm)
18"
(457 mm)
No change in measurements if connected
with drain illustrated. (K-7272)
Integral Flange
Detail
1-1/4"
(32 mm)
4-1/8"
(105 mm)
Lumbar
Angle 42˚
2-1/2"
(64 mm)
19"
(483 mm)
20-1/4"
(514 mm)
1-1/4"
(32 mm)
Product Diagram
ARCHER
®
ARCHER
®
6’ BUBBLEMASSAGETM BATH WITH BASKTM HEATED SURFACE
Page2of2
1201681-4-
B