Rough-In Guide

Product Information
Applicable product:
Integral apron, heater, left drain K-1114-HL
Integral apron, heater, right drain K-1114-HR
Fixture*:
Bathing well:
Basin area, bottom 55″ (139.7 cm) x 23-1/4″ (59.1 cm)
Basin area, top 64″ (162.6 cm) x 32″ (81.3 cm)
Weight 149 lbs (68 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 78.5 gal (297 L)
* Approximate measurements for comparison only.
VHzA
Pump: 1-speed 120 60 7.5
Heater: 1.5 kW 120 60 12.5
Minimum access panel
pump/control (required):
20″ (50.8 cm) W x
15″ (38.1 cm) H
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control 120 V, 15 A, 60 Hz
Heater 120 V, 15 A, 60 Hz
Locate the outlets behind the whirlpool and within 24″ (61 cm)
of the pump and heater.
Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of
41 lbs/square foot (199.6 kg/square meter) loading.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
72" (182.9 cm)
42" (106.7 cm)
1-1/2" OD
3/8" (1 cm)
21"
(53.3 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Recommended faucet area
No change in measurements if connected with
drain illustrated. (K-11677 or K-11677M)
3-1/2"
(8.9 cm)
1-1/4"
(3.2 cm)
21" (53.3 cm)
1-1/4" (3.2 cm)
1-1/4"
(3.2 cm)
Tile Flange
Detail
11-1/16" (28.1 cm)
3-3/4"
(9.5 cm)
1047192-1-C 2 Kohler Co.