Liquid Cooled Vertical Crankshaft Service Manual

11.23

Section 11

Reassembly

8. Lift the by-pass hose and secure it within the

metal clip under the main support bracket. See

Figure 11-78.

Figure 11-78. Seating By-pass Hose.

Install Electric Starter

1. Position the starter mounting plate onto the

crankcase so that the cutout is at the bottom,

and the offset is toward the dipstick tube. Install

and torque the two hex. flange mounting screws

to 15.3 N·m (135 in. lb.). See Figure 11-79.

Figure 11-79. Torquing Adapter Plate Screws.

2. Mount the electric starter to the plate and start

the two mounting bolts into the crankcase. The

lifting bracket must be on the bolt closest to the

solenoid, and should extend down and out.

3. Slide the adjacent radiator support bracket under

the heads of the starter bolts and behind the

lifting bracket. Check that the starter is square to

the crankcase, then torque the mounting bolts to

15.3 N·m (135 in. lb.). See Figure 11-80.

Figure 11-80. Torquing Starter Mounting Bolts.

4. Attach the leads to the solenoid and starter.

5. Push down on the lower tube/hose assembly

and securely tighten the metal tie strap around

the lower tube/hose assembly using a pliers.

Make sure the head of tie strap is below the top

of the tube where it will not be contacted by the

flywheel. Cut off all excess strap material. See

Figure 11-81.

Figure 11-81. Tightening Tie Strap with Pliers.