Installation Guide

2. Install the Interface
Install the mounting bracket according to the instructions packed
with the bracket.
Apply grease (provided) into both ends of the coupler.
Connect the cable from the wall and the interface into the coupler.
Ensure the cables fully click into the coupler.
Feed the cable and coupler into the hole in the wall. Ensure a
drip loop is made.
Tilt the top of the interface onto the mounting bracket, then press
the bottom until it clicks in place.
Connect
the cables.
Drip Loop
Press to
click in place.
Tilt onto
the bracket.
Apply grease
in both ends.
Kohler Co. 5 1194161-2-A