Installation Guide

10. Install the Door
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass directly on the floor.
IMPORTANT! Perform the following steps with two installers.
Place a bushing in the upper hole in the side lite glass panel where the top fixed hinge will be
installed.
Place the gasket over the top corner of the side lite glass panel so that the hole in the gasket aligns
with the hole in the glass.
Installer #1
Lift the door into a position so that the hinge pin is above the fixed hinge.
Carefully lower the door so the hinge pin fits into the bottom hinge. Hold the door in place while
installer #2 installs the top fixed hinge.
Installer #2
Place the top fixed hinge over the gasket of the side lite glass panel and hinge pin.
Align the hole in the top fixed hinge with the bushing and carefully position the top fixed hinge on
pin.
Insert the large diameter screw through the bracket into the bushing and tighten until flush with the
surface. Do not overtighten.
Top Fixed Hinge
Hinge Pin
Gasket
Bushing
Screw
Kohler Co. 15 1064866-2-B