Installation Guide

9. Install the Strike Side Glass Panel - 60″ (152.4 cm) Models
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set the unframed tempered glass directly on the floor.
Insert the strike lite filler into the bottom track.
Install wall brackets following the steps in the ″Install the Hinge-Side L-Brackets″ section, using the
strike lite filler to position the lower wall bracket.
NOTE: There is a label on the strike side panel identifying the ″non-coated side″ of the panel. If the strike
panel is coated glass, the side of the glass with the ″Non-coated side,″ label should face towards the
outside of the shower.
Carefully place the wall jamb on the edge of the strike lite glass panel, opposite the attached hinge
and exactly in the middle of the vertical edge of the strike lite glass panel.
Place a bushing in the bottom hole of the strike lite glass panel.
Position the gasket over the edges of the strike lite glass panel, with the top holes aligned with the
bushing.
Apply a bead of silicone sealant to the groove of the strike lite filler.
Align the bushing with the pin on the ″L″ brackets and position the strike lite glass panel on the
strike lite filler with the pins of the L-brackets through the bushings.
IMPORTANT! Make sure the glass panel is as close to the wall as possible while still remaining plumb.
Place the outside plates onto the pins of each of the L-brackets and securely fasten with the
supplied screws.
Wipe off excess silicone sealant.
Install the glass to glass seal on the edge of the strike lite glass panel. Position the triangular
protrusion on the back side of the seal so it is aligned with the edge of the glass.
Strike
Lite Filler
Screw
Bushing
Outside Plate
Gasket
Apply Silicone Sealant.
Wall Jamb
Strike Lite Filler
Strike Lite
Glass Panel
"L" Bracket
Glass To
Glass Seal
Top View
1064866-2-B 14 Kohler Co.