Installation Guide

5. Install the Bottom Bracket
NOTE: There is a label on the side lite panel identifying the ″non-coated side″ of the panel. The
non-coated side of the panel should face the outside of the shower when bottom bracket is being installed.
Place a bushing in the lower hole in the side lite panel where the bottom fixed hinge will be
installed.
Place the gasket on the lower corner of the glass, aligning the hole in the gasket with the hole in the
glass.
Gently slide the bottom fixed hinge over the gasket, aligning the hole in the bracket with the hole in
the glass.
Insert the supplied screw into the side of the bottom fixed hinge and fasten.
Tighten the screw until is it snug and/or flush with the surface. Do not overtighten.
Side Lite
Screw
Bottom Fixed Hinge
Gasket
To Inside
of Shower
Bushing
1064866-2-B 10 Kohler Co.