Installation Guide

4. Install the Bath
NOTE: To provide access for securing the connections, temporarily position block spacers on opposing
ends between the shroud and the bath rim. Position the blocks to avoid damaging the alignment guides
located under the bath rim. The type of alignment guides may vary by product.
With help, carefully lift the bath into place over the shroud and onto the temporary blocks.
Secure all drain connections and fittings according to the drain instructions.
Install the faucet and trim according to the faucet and trim instructions. Make sure that there is
adequate support under the bath rim to support the faucet. Refer to the ″Prepare the Rim-Mount
Faucet (Optional)″ section.
Carefully remove the blocks and make sure the bath rim engages the top of the shroud on all sides.
Ensure all alignment guides are inside the shroud; there should be no gap between the bath and the
shroud.
NOTICE: The type of alignment guides may vary by product.
Install the drain flange and overflow cover according to the drain instructions.
Close the bath drain. Fill the bath to the overflow, and check for leaks.
If desired, apply a thin, continuous bead of clear or color-matched silicone sealant to the seam
between the shroud and the finished floor.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
•
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
•
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
•
Do not allow cleaners to soak on surfaces.
•
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.
Temporary
Blocks
Alignment
Guides
1237787-2-G 6 Kohler Co.