Install Manual

TP-6906 6/1448 Section 3 Generator Reconnection
1. Press the Select button to enter the main menu.
2. Press the down arrow button to navigate to the
Genset System menu. See Figure 3-4.
3. Press the Select button to enter the genset system
menu.
4. Press the down arrow button, if necessary, to step
to the setting that you want to change.
5. When the setting is displayed (for example,
System Voltage), press the select button. The
value will flash.
6. Press the up or down arrow buttons to increase or
decrease the setting.
Press:
Changing System Settings on the RDC2 Controller
Press: Display:
Overview ---->
1.2 h
Display:
Press: Display:
Genset ---->
System
System Voltage:
240 V
7. When the desired setting is shown, press Select.
The value stops flashing.
8. Press the down arrow to step to the next setting.
9. To exit, press the down arrow button until Return
is displayed.
10. Press the Select button to exit the menu.
11. Press Auto to signal the controller to exit the
menus and return to the generator set status
display.
Press: Display:
System Voltage
240 V
Press: Display:
Press: Display:
System Freq:
60 Hz
Press: Display:
R e t u r n -- -- >
Press: Display:
System Voltage
220 V
Overview ---->
1.2 h
AUTO
Press:
Display:
Genset State
Standby
Note: If no buttons are pushed, the controller returns
to the status display after 5 minutes.
Press:
Display:
System Voltage
220 V
Figure 3-5 Changing Genset System Settings