Install Manual

TP-6906 6/1436 Section 1 Installation Instructions

6. Add coolant to the radiator to just below the

overflow tube on the filler neck. See Figure 1-24.

7. Replace the radiator’s pressure cap.

8. Maintain the coolant level in the coolant overflow

bottle between the Hot and Cold markings. See

Figure 1-24 for the coolant overflow bottle location.

Model

Coolant Capacity, L (gal.)

Engine

24RCL, 3 0RCLH 12.4 (13.1)

Figure 1-23 Coolant Capacity

1. Engine coolant fill (pressure cap not shown)

2. Overflow tube

3. Coolant overflow bottle

4. Oil cooler hoses (30RCLH only)

GM90230

Figure 1-24 Coolant Fill

1.8 Prestart Installation Check

Review the entire installation section. Inspect all wiring

and connections to verify that the generator set is ready

for operation. Check all items in the following Prestart

Checklist.

Prestart Checklist

Air Cleaner. Check that a clean air cleaner element is

installed to p revent unfiltered air from entering the

engine. See the generator set operation manual for

instructions.

Air Inlets. Check for clean and unobstructed air inlets.

Battery. Check for tight battery connections. Consult

the battery manufacturer’s instructions regarding

battery care and maintenance.

Coolant Level. Check the coolant level as described in

Section 1.7.

Enclosure. Check that all enclosure panels and internal

baffling are in place.

Oil Level. Maintain the oil level at or near, not over, the

full mark on the dipstick.

Operating Area. Check for obstructions that could

block the flow of cooling air. Keep the air intake area

clean. Do not leave rags, tools, or debris on or near the

generator set.