Installation Guide

4. Route the Cables
IMPORTANT! Several of the included bath components will be powered by the control amplifier via 25’
(7.6 m) cables. Plan the location of the control amplifier so the cables will reach without being under
tension.
Carefully cut the cable tie securing the coiled transducer wires to the back of the bath.
Route the transducer wires through the framing to the control amplifier location, drilling 1″ (52 mm)
holes where needed.
If equipped, route the chromatherapy cable from the bath to the planned amplifier location. Follow
the same route as the transducer wires.
Route the user interface cable through the framing from the planned user interface location to the
control amplifier location. Make sure the larger Ethernet-style connector is at the control amplifier
end. Include a drip loop.
NOTE: If used, route an auxiliary-in cable (not included) to the control amplifier location.
Power Outlet
Transducer
Wires
Chromatherapy
Cable
Chromatherapy
Cable (If Equipped)
Transducer
User Interface Cable
Ethernet Connector
User Interface
Kohler Co. 11 1297608-2-B