Installation Guide

6. Prepare the Site – Deck-Mount

NOTE: Provide an access panel under the bath deck for water

supply connections.

NOTE: Reference the ″Rough-In – Deck-Mount″ section of this

guide before proceeding.

Position the support plate on the bath deck where the water

supply tubing will be located. Trace the holes.

Verify that the location of the plate will allow the bath ﬁller spout

to reach into the bath.

Verify the distance between the centerline of the marked holes is

5-15/16” (151 mm).

NOTE: If a hole saw will be used, drill outside the line of the

marked holes.

Drill the holes using a 1-9/16” drill bit or 1-1/2″ hole saw.

Remove any debris after drilling.

Verify the drilled holes will accommodate the riser tubes. Adjust

the hole diameter slightly, if needed.

Secure the support plate to the unﬁnished bath deck with the

eight (provided) wood screws.

Bath Deck

Screw

5-15/16"

(151 mm)

Support Plate

Check the reach.

1219580-2-A 10 Kohler Co.