Installation Guide

Install the Showerhead
NOTE: The shower arm with flange are not provided.
Remove the existing showerhead and shower arm, if applicable.
Install the shower elbow. Make sure the elbow is securely
mounted and has adequate strength to support the showerhead.
Apply a bead of plumbers putty or other sealant to the back of
the flange.
Place the flange onto the long end of the shower arm as shown.
Apply sealant tape to the threads of each end of the shower arm.
Install the shower arm to the shower elbow and tighten securely
with a clean strap wrench.
Press the flange against the finished wall/ceiling and secure to
the shower arm by tightening the setscrew.
Remove any excess plumbers putty.
Turn on the water to flush any debris through the shower arm.
Turn off the water.
Install the showerhead to the shower arm and tighten securely
with a clean strap wrench.
Check all connections for leaks.
NOTE: After each use some water may remain in the showerhead.
To prevent dripping, tilt the showerhead to drain.
Showerhead
Elbow
Apply
plumbers putty.
Shower Arm
(not included)
Flange and
Setscrew
(not included)
WallCeiling
Apply
sealant tape.
Apply sealant tape.
Kohler Co. 3 1141989-2-G