Instructions / Assembly

MOUNTING
1. Determine placement of panel on wall. Note: If panel is
positioned with clips mounted on studs that are 16" on
center, panel will be ideally secured.
2. Use stud nder and level to plan out positioning of both
impaling clips and the four anchor screws. For best
results, place the clips 16 inches apart horizontally.
3. Mark your drill holes for your clips with painter’s tape
or a pencil/pen.
4. Drill all holes into your drywall or wood surface.
5. Align the mounting clips so that the screw holes are over
the holes you have just drilled. Use your screwdriver to
screw in the anchor screws. Do this for all four anchor
screws for your two impaling clips.
POSITIONING THE PANEL
6. Your acoustic panel should now easily mount to the
secured clips as the berglass material will naturally
diginto the 45 degree mounting tip edge on the front
oftheclips.
7. Enjoy the sound improvement this acoustic panel will
give your home or ofce.
TOOLS YOU NEED
 Phillips Screwdriver
 Level
 Painters Tape or Pencil/Pen
 Stud Finder
 Cordless Drill and Drill Bit (size)
 Optional
3
⁄16" Carbide Tipped Drill Bit
(If you don’t have 16" studs on center)
Acoustic Panel
with ECOSE
®
Technology
INSTALLATION INSTRUCTIONS
KNAUF INSULATION, INC.
One Knauf Drive
Shelbyville, IN 46176
Technical Support
[phone] ext. 8727
[e-mail]
10-21
© 2021 Knauf Insulation, Inc.
PARTS YOU NEED
 One (1) 24" x 24" Square Panel
 Two (2) Angled Impaling Clips
 Four (4) Anchor Screws
(not included)