Operation Manual

Tech Support: 1-800-KLIPSCH

1) Grasp the Edison Socket with one hand, and with

the other hand screw the LightSpeaker

5 into

the socket on the pigtail. Be careful: Always turn

the speaker not the socket. Turning the socket will

twist up the pigtail and put unneeded stress on the

connection.

2) Grasp the LightSpeaker

5 by the light bridge (see

section titled “Removing the Lens” below) and while

holding it level and steady, firmly push it back into the

lighting fixture. It is not necessary to use the light bridge

to install LightSpeaker

, so do so only if you find it helpful.

3) Be certain this trim ring contacts the ceiling

uniformly all of the way around your LightSpeaker

5 and that the LightSpeaker

5 itself is seated

securely into the electrical socket.

Removing your LightSpeaker

5 from a recessed

lighting fixture.

Remove the lens (See Installing and Removing the Lens),

and while pushing up lightly applying a 1/4 turn in a

clockwise direction. Gently pull down on the light bridge.

See “Removing the lens” below.

Step 8: Pairing The Transmitter to the speakers: See

Complete System Manual or go to www.Klipsch.com.

Light Bridge