Operation Manual

STEP 2 (CONTINUED)
IF USING SUPPLIED BRACKET
A. Run speaker wire through hole in bracket back and attach wall
bracket to wall
B. Slide speaker partially onto bracket arms and channel wire
from back to front
C. To keep speaker on bracket while adjusting use Phillips head
screwdriver and partially screw in front top/bottom bracket
screws (2-3 revolutions) then gently pull out speaker to detente
position 3/4ths of way on bracket.
D. WITH SPEAKER STILL PULLED OUT TO FIRST “STOP”
POSITION ON BRACKET adjust speaker to desired angle on wall.
Speaker
Wires
OR
A.
B.
C. D.
Speaker
Wires
OR
Speaker
Wires
OR
Speaker
Wires
OR
Use #10-#12, 2.5-3 INCH
Pan Head Screws