Health and safety

10
freezer compartments.
Appliances could have special
compartments (Fresh Food
Compartment, Zero Degree
Box,...).
In case not differently specified
in the specific booklet of
product, they can be removed,
maintaining equivalent
performances.
C-Pentane is used as blowing
agent in the insulation foam and
it is a flammable gas.
INSTALLATION
Installation and repairs must be
carried out by a qualified
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part of
the appliance unless specifically
stated in the user manual.
Children should not perform
installation operations. Keep
children away during
installation. Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, during and
after the installation.
The appliance must be handled
and installed by two or more
persons. Use protective gloves
to unpack and install the
appliance.
Be careful not to damage the
floors (e.g. parquet) when
moving the appliance.
Install the appliance on a floor or
support strong enough to take
its weight and in a placesuitable
for its size and use.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest
Aftersales Service.
The appliance must be
disconnected from the power
supply before any installation
operation.
During installation, make sure
the appliance does not damage
the power cable.
To guarantee adequate
ventilation, leave a space on
both sides and above the
appliance.
The distance between the rear
of the appliance and the wall
behind the appliance should be
50 mm, to avoid access to hot
surfaces.
A reduction of this space will
increase the Energy
consumption of product.
Only activate the appliance
when the installation has been
completed.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant
circuit is fully efficient.
Make sure the appliance is not
near a heat source.
ELECTRICAL WARNINGS
For installation to comply with
current safety regulations, an
omnipolar switch with minimum
contact gap of 3 mm is required
and the appliance must be
earthed.
If the fitted plug is not suitable
for your socket outlet, contact a
qualified technician.
The power cable must be long
enough to connect the
appliance, once fitted in its
housing, to the main power
supply. Do not pull the power
supply cable.
If the power cable is damaged,
replace with an identical one.
The power cable must only be
replaced by a qualified
technician in compliance with
the manufacturer instruction
and current safety regulations.
Contact an authorized service
center.
For appliances with fitted plug,
if the plug is not suitable for you
socket outlet, contact a qualified
technician.
Do not use extension leads,
multiple sockets or adapters.
Do not operate this appliance if
it has a damaged mains cord or
plug, if it is not working
properly, or if it has been
damaged or dropped. Keep the
cord away from hot surfaces.
The electrical components must
not be accessible to the user
after installation.
Do not touch the appliance with
any wet part of the body and do
not operate it when barefoot.
CLEANING AND
MAINTENANCE
Wear protective gloves for
cleaning and maintenance.
The appliance must be
disconnected from the power
supply before any maintenance
operation.
Never use steam cleaning
equipment.
Do not use abrasive or harsh
cleaners such as window sprays,
scouring cleansers, flammable
fluids, cleaning waxes,
concentrated detergents,
bleaches or cleansers containing
petroleum products on plastic
parts, interior and door liners or
gaskets. Do not use paper
towels, scouring pads, or other
harsh cleaning tools.