Owner's Manual
Table Of Contents
- ICE MAKER SAFETY
- Ice Maker Safety
- IMPORTANT CONSUMER INFORMATION
- Important Consumer Information
- ICE MAKER MAINTENANCE AND CARE
- How Ice Maker Works
- Normal Sounds
- Water Filtration System
- Interior Cleaning
- Exterior Cleaning
- Vac Extn Time Without Use
- INSTALLATION INSTRUCTIONS
- Unpack Ice Maker
- Location Requirements
- Electrical Requirements
- Drain Connection Requirements
- Drain Pump Installation (on some models)
- Water Supply Requirements
- Connect Water Supply
- Connecting the Drain
- Leveling and Securing
- Custom Wood Panel
- Auxiliary Grille Installation
- SECURITE DE LA MACHINE A GLACONS
- Sécurité de la machine à glaçons
- RENSEIGNEMENTS IMPORTANTS POUR LE CONSOMMATEUR
- Renseignements importants pour le consommateur
- ENTRETIEN ET REPARATION DE LA MACHINE A GLACONS
- Comment utiliser la machine à glaçons
- Sons normaux
- Système de filtration d’eau
- Nettoyage de l’intérieur
- Nettoyage des surfaces externes
- Vacances ou longue période d’inutilisation
- INSTRUCTIONS D'INSTALLATION
- Déballage de la machine à glaçons
- Exigences d’emplacement
- Electrical Requirements
- Exigences concernant le raccordement au drain
- Installation de la pompe de vidange (sur certains modèles)
- Spécifications de l’alimentation en eau
- Raccordement à la canalisation d’eau
- Raccordement de la vidange
- Leveling and Securing
- Panneau de bois personnalisé
- Installation de la grille auxiliaire
20
7. Replace the top and bottom end caps into the door. Fix the
bottom end cap using screw through the bottom metal bracket
hole.
Auxiliary Grille Installation
The auxiliary grille is an optional part that can be used to align the
toe grille with the rest of the cabinets (while not obstructing
ventilation of the ice maker).
Tools required:
� Torx T20 screwdriver
� 1/8ʺ straight drill bit and power drill
1. First, complete all installation steps and install leveled ice
maker into the cabinet. Ensure ice maker is flush with the
adjacent cabinets.
2. Unpack kit by removing outer cushion packaging and
discarding packaging material.
3. Remove screws that are taped onto the inside of the auxiliary
grille.
4. Place grille onto cabinetry. Align part so that grating pattern on
the auxiliary grille matches that of the toe grille on the ice
maker.
5. Center auxiliary grille on cutout for ice maker. Mark hole
locations on each side of auxiliary grille on cabinet.
6. Using power drill and a 1/8ʺ drill bit, drill holes in cabinet.
This is to fit screws of size 818 x 0.750.
7. Using the Torx T20 screwdriver, screw auxiliary grille onto
cabinet.
NOTE: For future service of ice maker, auxiliary kit must be
removed prior to the removal of the ice maker from the
cabinets.
Ice Maker Installation Checklist