Manual

Changing Front Panels
Lower Panel:
1. Remove two screws (F) located under panel
assembly.
2. With hands placed under ends of panel
assembly (H), turn out and lift assembly off
of support bracket (G).
3. Place panel assembly on a smooth, flat
surface and remove the two screws (C)
from either side of the trim. Remove the
loosened piece of trim.
4. Slide the color panel out. Handle the panel
carefully to avoid scratching or bending the
panel. Turn the panel to the desired color.
Slide the color panel into position.
o
6.
=
8.
Replace the trim and screws (C).
Taking the assembled lower panel (H),
insert the top of the assembly onto the
support bracket (G) until the seal (I) on the
lower panel assembly is seated properly
against the dishwasher tank.
Replace the screws (F).
Check that upper and lower panels are
secure.
9. Reconnect electrical power supply.
Remove
screws
from trim piece.
C
Replace all
panels, trim
pieces, and
screws.
H
Optional front panels
Wood and decorative panels
The front trim willaccommodate a custom
wood front or a decorative panel insert, 1,_inch
thick, weighing no more than 10 pounds. Any
wood panel or decorative panel weighing over
4 pounds requires heavy-duty door springs.
For more information on installing a custom
wood front, refer to the Dishwasher Installation
Instructions. If you have misplaced these
instructions, or to order heavy-duty springs
(part number 9741247), contact your local
KitchenAid®dealer or call 1-800-422-1230.
Solid colors
If the two colors provided with your dishwasher
do not match your kitchen decor, optional panels
are available from your KitchenAid dealer in a
variety of decorator colors.
Product Damage
Heavy duty door spring kit, part number
9741247, must be used with custom
panels that weigh more than 4 pounds.
Order kitfrom your dealer or authorized
parts distributor.
Maximum door panel weight is 10
pounds.
Failure to follow these instructionscould
cause product damage.
23