Installation guide

10. Attach the panel assembly to the door by reinstalling the
three screws on each side; do not tighten completely.This
will hold the panel assembly in place on the door frame.
3 screws
customer-supplied
custom panel
11. Align the top edge of the customer-supplied custom panel
with the top of the console.
12. Drill four 1/8" pilot holes 1/2" (13 ram) deep, into the
customer-supplied custom panel, through the holes in the
top corners and latch area of the inner panel.
_inner panel
drill through
these holes
13. Install the four #8-18
1-3/8" screws along the top
of the inner panel. 1-3/6"screw
14.Tighten the six side screws reinstalled in Step 10.
15. Before installing side trim, clean the sides of door panel.
16. Side trim pieces are held in
place with double-faced
adhesive tape. Make sure
trims are precisedly aligned;
once the trim is installed it
can not be moved.
tape on inside of
trim
Option 3: For models KUDCO21R, KUDIO21R, KUDPO21R
KUDSO21R
All models require an accessory option to attach custom
panels. Kit No. 8171555 (black), 8171556 (white) or 8171557
(biscuit) are available.To order, call customer service at
800-444-1230.
NOTE: A custom full front panel must weigh no more
than 14 pounds (6.3 kg) and must be made to specific
dimensions. It is recommended that a cabinetmaker cut the
custom panel because of the precise dimensions needed.
iMPORTANT: Use a moisture resistant sealer on both sides
and all edges of the panel to protect it from humidity.
NOTE:These dimensions are for frameless custom panel
models with a 4-inch (10.2 cm) console only.
23-3/8" (59.3 cm)_'_5_25-29/32'' (65.8 cm)
3/4"
(19.1 mm)
1/8"
custom panel dimensions
/8" (3.2 cm)
_This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe
kick, adjust the height of the wood panel accordingly. Not recommended for
toe kicks greater than 6" (15.2 cm).
1. With aTORX ÷ screwdriver, remove three screws from both
sides of door; hold the outer panel up while removing the
screws,
3screws
outer panel
2. Gently set outer panel aside.
3. Lay the cutomer-supplied custom panel face down on a
protective, non-scratching surface.
4. Position the outer panel on the back of the customer-
supplied custom panel as shown; make sure top edge of
the outer panel is aligned with the top edge of the
customer-supplied custom panel, and both panels are
centered side to side.
mark 4
inner holes
ign top
outer panel edges
customer-supplied
custom panel
5. Mark all four hole locations; remove outer panel and drill
3/32" pilot holes 1/2" (13 ram) deep, in customer-supplied
custom panel.
15