Dishwasher User Manual

CONNECTING THE DRAIN LINE

Remove the red plug from the dishwasher check valve and use a hose clamp (not supplied) to connect the prepared

drain line direc!ly to the dishwasher check valve (Fig. 15).

Make sure there are no sharp bends or kinks anywhere in the drain line which might restrict water flow.

Remove

red

plug

DIshwasher valve

Fig. 15

CAUTION: Put towel below dishwasher valve area

before removing red plug. Every KitchenAid

dishwasher is completely tested at the factory. A small

amount of water (less than l/z cup (125 ml)) may still

be In the dishwasher valve area from our quality

assurance testing.

CONNECTOR

GROUND 2

WIRE

Fig. 16

CONNECTING THE ELECTRICAL SUPPLY

BE SURE ELECTRICAL POWER IS TURNED OFF AT THE CIRCUIT BREAKER OR FUSE BOX.

The dishwasher must be properly grounded before operating by connecting to a suitable ground in compliance

with the Canadian Electrical Code and/or local electrical codes.

A - Remove junction box from dishwasher. B - Install a C.S.A. certified connector or strain relief bushing.

C - Connect white lead to white lead and black lead to black lead with wire nuts, and secure ground wire

in the copper ground connector (Fig. 16). D - Reinstall junction box.

When house wiring is aluminum. use C.S.A. certified aluminum to copper connectors

MAKE SURE THAT WATER SUPPLY LINE, DRAIN LINE, AND WIRING DO NOT TOUCH ANY EXPOSED

TERMINALS OF DISHWASHER WIRING.