Manual

Installation

1. Remove the mounting screws attaching the foot pedal to the

compactor. Remove the foot pedal.

7. Reinstall the toe guard using the existing screws and 1/2"

washer. Then, reinstall the foot pedal.

A. Mounting screws

B. Foot pedal

2. Remove the mounting screws attaching the toe guard to the

compactor. Remove the toe guard.

3. Remove the mounting screws attaching the decorative panel

to the compactor. Remove the decorative panel and discard

the mounting screws.

4. Align the bottom of the custom panel with the bottom of the

drawer front.

5. Secure the panel from the back using four #8 x 1" wood

screws as shown.

6. Attach a 15" x 1/2"(38.1 cm x 13 mm) quarter-round filler

along the top of the drawer front using glue or screws.

A. Custom panel C. Panel screw E. Washer

B. 15" x ½" (38.1 cm x locations F. Toe guard

13 mm) quarter-round filler D. Toe guard screw

COMPACTOR USE

How '¥1our Compactor Works

The compacting ram is the part of the compactor which

compresses the trash. The compacting ram does not go to the

bottom of the drawer. You will not see compacting of trash the

first few times you load the compactor.

NOTE: The compactor drawer should be more than 1/2full before

the compactor can begin to compress the load.

You may hear a noise when glass breaks. Strong glass bottles

may not break at all. The trash in a full compactor bag will be

about 1/4the size of its original bulk.

Load bulky trash, bottles, and cans in the center of the drawer.

Bottles or cans not placed in the center may become caught

between the ram and the drawer. The Drawer Monitor Switch

then senses a "misload" and causes the ram to return to the "up"

position without compacting.

r:-:..-'" "'- "<:--H"tt--.